Notes

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
======Links======
[[http://support.dell.com/support/edocs/stor-sys/switch/24port/mcdata/cli.pdf|McDATA OPENconnectors Command Line Interace User Manual]] via Dell.com. \\

======Notes======
All commands below are valid from a Root> prompt. Tested on an IBM SAN32M-2. \\

Show currently active zoning configuration:
<code>
config zoning showActive
</code>
Show the current pending zoning configuration:
<code>
config zoning showPending
</code>
Replace the pending zoning configuration with the currently active zoning configuration (before editing):
<code>
config zoning replaceZoneSet
</code>
Add a WWN to an existing zone in the pending zoning configuration:
<code>
config zoning addWwnMem Default_Zone_FSW1 21:00:00:24:FF:04:AA:BB
</code>
Delete a WWN from an existing zone in the pending zoning configuration:
<code>
config zoning deleteWwnMem Default_Zone_FSW1 21:00:00:24:FF:04:AA:BB
</code>
Move the pending zoning configuration to the active zoning configuration:
<code>
config zoning activateZoneSet
</code>
Show active WWN's:
<code>
show port status
</code>
Show active aliasses:
<code>
show activeAlias
</code>