Notes

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
======OS - Linux - Networking - Bonding - Notes======

[[http://www.cloudibee.com/network-bonding-modes/|CloudiBee - Linux Network bonding – setup guide]]


Check the status of a bond:
<code>
cat /proc/net/bonding/bond0
</code>
Source:[[https://kudithipudi.org/2010/07/30/how-to-check-status-of-bond-interface-in-linux/|Kudithipudi.org - HOW TO : Check status of bond interface in Linux]]

Change active slave in an active/backup bond (to em1):
<code>
ifenslave -c bond0 em1
</code>
Source:[[https://www.thegeekdiary.com/redhat-centos-how-to-change-currently-active-slave-interface-of-bonding-online/|The Geek Diary - RedHat / CentOS : How to change currently active slave interface of bonding online]]

Change the active slave in an active/backup bond on older versions of Linux:
<code>
# Remove the currently active interface from the bond
echo -eth1 > /sys/class/net/bond0/bonding/slaves
# Re-add the interface to the bond
echo +eth1 > /sys/class/net/bond0/bonding/slaves
</code>
Source:[[http://blog.erben.sk/2010/09/10/how-to-change-active-slave-when-running-bonding-active-backup/|blog.erben.sk - How to change Currently Active Slave when runnning bonding in active-backup mode]]


=====Create a bond (with vlan) on the commandline=====

With ifconfig and vconfig:
<code>
ifconfig eth2 down
ifconfig eth3 down
ifconfig bond0 up
ifenslave bond0 eth2 eth3
vconfig add bond0 4
ifconfig bond0.4 10.20.4.200 netmask 255.255.255.0
ifconfig eth2 up
ifconfig eth3 up
ifconfig bond0.4 up
</code>

With (only) ip:
<code>
ip link set dev eth2 down
ip link set dev eth3 down
ip link add bond0 type bond
ip link add link bond0 name bond0.4 type vlan id 4
ip address add 10.20.4.200/24 dev bond0.4
ip link set eth2 master bond0
ip link set eth3 master bond0
ip link set dev eth2 up
ip link set dev eth3 up
ip link set dev bond0 up
ip link set dev bond0.4 up
</code>

Sources:
  * [[https://developer.ridgerun.com/wiki/index.php/Network_Interface_Bonding|RidgeRun Developer Wiki - Network Interface Bonding]]
  * [[https://sysadmincorner.wordpress.com/2012/04/06/configuring-vlan-interfaces-in-linux/|System Administrators Corner - Configuring VLAN interfaces in Linux]]
  * [[https://michlstechblog.info/blog/linux-configure-an-interface-for-a-tagged-vlan-by-ifconfig/|
Michls Tech Blog - Linux: Configure an interface for a tagged vlan by ifconfig]]
  * [[https://access.redhat.com/documentation/en-us/red_hat_enterprise_linux/7/html/networking_guide/sec-vlan_on_bond_and_bridge_using_ip_commands|Red Hat - Enterprise Linux 7 - 10.6. VLAN on Bond and Bridge Using ip Commands]]