McDATA OPENconnectors Command Line Interace User Manual via Dell.com.

All commands below are valid from a Root> prompt. Tested on an IBM SAN32M-2.

Show currently active zoning configuration:

config zoning showActive

Show the current pending zoning configuration:

config zoning showPending

Replace the pending zoning configuration with the currently active zoning configuration (before editing):

config zoning replaceZoneSet

Add a WWN to an existing zone in the pending zoning configuration:

config zoning addWwnMem Default_Zone_FSW1 21:00:00:24:FF:04:AA:BB

Delete a WWN from an existing zone in the pending zoning configuration:

config zoning deleteWwnMem Default_Zone_FSW1 21:00:00:24:FF:04:AA:BB

Move the pending zoning configuration to the active zoning configuration:

config zoning activateZoneSet

Show active WWN's:

show port status

Show active aliasses:

show activeAlias