hardware:fibrechannel:switch:mcdata:cli
Links
McDATA OPENconnectors Command Line Interace User Manual via Dell.com.
Notes
All commands below are valid from a Root> prompt. Tested on an IBM SAN32M-2.
Show currently active zoning configuration:
config zoning showActive
Show the current pending zoning configuration:
config zoning showPending
Replace the pending zoning configuration with the currently active zoning configuration (before editing):
config zoning replaceZoneSet
Add a WWN to an existing zone in the pending zoning configuration:
config zoning addWwnMem Default_Zone_FSW1 21:00:00:24:FF:04:AA:BB
Delete a WWN from an existing zone in the pending zoning configuration:
config zoning deleteWwnMem Default_Zone_FSW1 21:00:00:24:FF:04:AA:BB
Move the pending zoning configuration to the active zoning configuration:
config zoning activateZoneSet
Show active WWN's:
show port status
Show active aliasses:
show activeAlias
hardware/fibrechannel/switch/mcdata/cli.txt · Last modified: 2011/01/11 09:35 by bas